The average temperature of the fixtures is 82 degrees F
Yes, the fixtures are full spectrum! which is what you would want for both veg and flower
Different fixtures vary from 2’x2’ to 4’x4’ But the larger models (octoled and pentaled) can be stretched to a 5’x5’ in flower and a 6x6’ in veg
That would of course depend on how many units you are running in the room and how often you are exchanging the air in the room. Running the fixtures at night time helps with temperature. If you do need to cool the room at all it would be nominal in comparison to HPS and CMH lighting due to the avergage temperature radiating from the units being 82 Degrees F. A properly circulated 13’x13’ room with 6 units does not need AC (in some states power is even cheaper at night)
We always recommend supplementing CO2 with our lighting. With the right set up and having the room dialed in you could see an increase in yield. CO2 also helps the plant at elevated temperature levels. So you could have the room 90F without worry
These fixtures are IP 65 water resistant and do not run at a high temperature making them safe for a VPD dialed room. HPS and CMH can be dangerous in a VPD dialed room. Gas filled bulbs explode and catch fire more commonly when correct VPD is being utilized.
Our heaviest model is roughly 22 pounds
Whatever you feel comfortable with! Our ballasts are designed to be ran at up to 277V. Amperage will of course be cut in half and wattage from the wall will slightly decrease at 240V
If it is plug and play you could technically… but we recommend you upgrading to a nema 6-15 240v power cord
Some assembly is required it just depends on the model. A lot of our fixtures are plug & play
Make sure it's at the right voltage (AC100v-277v) and power is in on position
First try to accessing the LED driver box and install a new LED driver box. If the problem persists replace the bar with a new one.
We recommend installing a new light bar in its place